FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2
2-92
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Installation Tasks
e. Click the Suppress RSCNs on zone set activations check box to
enable or disable this parameter. A check mark in the box
indicates the parameter is enabled, and is the default. When
the parameter is enabled (checked), attached devices do not
receive notification following any change to the fabric’s active
zone set. When the parameter is disabled, attached devices
(registered through the fabric format domain register) do
receive notification following any change to the fabric’s active
zone set.
3. Click Activate to save the information and close the dialog box.
4. Set the switch online. For instructions, refer to Set the Switch
Online or Offline on page 4-48.
Configure Fabric
Parameters
Perform this procedure to configure the fabric operating parameters,
including R_A_TOV, E_D_TOV, switch priority, and interop mode.
The switch must be set offline. To configure fabric parameters:
1. Ensure the switch is set offline. For instructions, refer to Set the
Switch Online or Offline on page 4-48.
2. At the Hardware View, select Operating Parameters, then Fabric
Parameters from the Configure menu. The Configure Fabric
Parameters dialog box displays (Figure 2-86).
Figure 2-86 Configure Fabric Parameters Dialog Box
a. At the R_A_TOV field, type a value between 10 through 1200
tenths of a second (one through 120 seconds).