FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2
Installation Tasks
2-89
Installation Tasks
• Configure preferred paths.
• Configure switch binding.
• Configure switch ports.
• Configure SNMP trap message recipients.
• Configure threshold alerts.
• Configure OpenTrunking.
• Enable SANpilot interface and Telnet access.
• Configure and enable e-mail notification.
• Configure and enable Ethernet events.
• Configure and enable call-home event notification.
Configure Switch
Identification
Perform this procedure to configure the switch name, description,
location, and contact person for the SAN management application.
The information appears in multiple dialog boxes throughout the
application. In addition, the Name, Location, and Contact variables
configured at the Configure Identification dialog box correspond
respectively to the SNMP variables sysName, sysLocation, and
sysContact. These variables are used by SNMP management
workstations when obtaining data from managed switches.
To configure the switch identification:
1. At the Hardware View, select Identification from the Configure
menu. The Configure Identification dialog box displays
(Figure 2-84).
Figure 2-84 Configure Identification Dialog Box