FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2
2-88
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Installation Tasks
3. To set the switch to periodically synchronize date and time with
the SAN management application:
a. Click the Periodic Date/Time Synchronization check box to
select the option (check mark in the box). The Date and Time
fields are greyed out and not selectable. Perform one of the
following options:
• Click Activate to enable synchronization and close the
Configure Date and Time dialog box. The switch date and
time synchronize with the SAN management application
date and time at the next update period (at least once
daily).
• Click Sync Now to synchronize the switch and SAN
management application immediately. The Date and Time
Synced information dialog box displays (Figure 2-83).
Figure 2-83 Date and Time Synced Dialog Box
b. Click OK to synchronize the date and time and close the Date
and Time Synced dialog box, then click Activate to enable
synchronization and close the Configure Date and Time dialog
box.
Task 19: Configure the Sphereon 4500 Element Manager
Application
Selectively perform one or more of the following configuration tasks
for the Sphereon 4500 Element Manager application according to the
customer’s installation requirements:
• Identify the switch to the SAN management (SANavigator 4.0 or
EFCM 8.0) application (configure switch identification).
• Configure switch and fabric operating parameters.