FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

2
2-50
McDATA Sphereon 4500 Fabric Switch Installation and Service Manual
Installation Tasks
a. The green liquid crystal display (LCD) panel illuminates.
b. The green hard disk drive (HDD) LED blinks momentarily,
and processor speed and random-access memory information
display momentarily at the LCD panel.
c. After a few seconds, the LCD panel displays the following
message pertaining to boot sequence selection (Figure 2-32):
Figure 2-32 LCD Panel During Boot Sequence
d. Ignore the message. After ten seconds, the server performs the
boot sequence from the basic input/output system (BIOS).
After successful boot and POST completion, the LCD panel
displays a Welcome!! message.
e. The server then continuously cycles through and displays the
following operational information at the LCD panel:
•Host name.
• System date and time.
• LAN 1 and LAN 2 IP addresses.
• Fan 1, fan 2, fan 3, and fan 4 rotational speed.
• Central processing unit (CPU) temperature.
• Hard disk capacity.
• Virtual and physical memory capacity.
10. If a POST error or other malfunction occurs, go to MAP 0000: Start
MAP on page 3-6 to isolate the problem.
11. Press the left edge (PUSH label) of the LCD panel to disengage
the panel and expose the CD-RW drive.
12. Insert a blank rewritable CD into the CD-RW drive and close the
LCD panel.
Boot from LAN?
Press <Enter>