FW 07.00.00/HAFM SW 08.06.00 McDATA Sphereon 4500 Fabric Switch Installation and Service Manual (620-000159-320, April 2005)

Installation Tasks

2-49

Installation Tasks

Figure 2-31 1U Management Server Connections

b. Connect the remaining end of the Ethernet cable to the LAN as

follows:

• If the server is installed on a customer-supplied LAN

segment, connect the cable to the LAN as directed by the

customer’s network administrator.

• If the server is installed on the McDATA- supplied Ethernet

hub, connect the cable to any available hub port.

6. If required, connect the management server to the customer’s

corporate intranet (public LAN interface). To connect the server:

a. As shown in Figure 2-31, connect one end of a customer-

supplied Ethernet patch cable to the left RJ-45 adapter (LAN 1)

at the rear of the server.

b. Connect the remaining end of the Ethernet cable to the

corporate intranet as directed by the customer’s network

administrator.

7. As shown in Figure 2-31, connect the 20-foot phone cord to the

left RJ-11 adapter (LINE) at the rear of the server and to a facility

telephone connection.

8. As shown in Figure 2-31, connect the AC power cord to the server

and to a facility power source or rack power strip that provides

single-phase, 90 to 264 VAC current.

9. When the power cord is connected, the server powers on and

performs power-on self-tests (POSTs). During POSTs: