958-000283-003, March 2005)

Table Of Contents

Edge Switch 2/24 installation guide 89

Cables

Connections to this device must be made with shielded cables with metallic RFI/EMI connector

hoods in order to maintain compliance with FCC Rules and Regulations.

Regulatory compliance identification numbers

For the purpose of regulatory compliance certifications and identification, your product has been

assigned a unique Regulatory Model Number. The RMN can be found on the product nameplate

label, along with all required approval markings and information. When requesting compliance

information for this product, always refer to this RMN. The Regulatory Model Number should not be

confused with the marketing name or model number of the product.

Laser device

All HP systems equipped with a laser device comply with safety standards, including International

Electrotechnical Commission (IEC) 825. With specific regard to the laser, the equipment complies

with laser product performance standards set by government agencies as a Class 1 laser product.

The product does not emit hazardous light.

Laser safety warning

WARNING! To reduce the risk of exposure to hazardous radiation:

• Do not try to open the laser device enclosure. There are no user-serviceable components inside.

• Do not operate controls, make adjustments, or perform procedures to the laser device other than

those specified herein.

• Allow only HP authorized service technicians to repair the laser device.

Certification and classification information

This product contains a laser internal to the fiber optic (FO) transceiver for connection to the Fibre

Channel communications port.

In the USA, the FO transceiver is certified as a Class 1 laser product conforming to the requirements

contained in the Department of Health and Human Services (DHHS) regulation 21 CFR, Subchapter

J. A label on the plastic FO transceiver housing indicates the certification.

Outside the USA, the FO transceiver is certified as a Class 1 laser product conforming to the

requirements contained in IEC 825-1:1993 and EN 60825-1:1994, including Amendment

11:1996 and Amendment 2:2001.