958-000283-003, March 2005)

Table Of Contents

Installing and configuring the Edge Switch 2/2464

Using HAFM from a remote location

Use this section to install the HAFM client on a remote workstation.

Remote workstation minimum requirements

The minimum requirements described in ”Minimum remote workstation requirements” on page 19

must be met to install HAFM on a remote workstation.

NOTE: For HAFM to function properly, compatible versions must be installed on both the client

machines and the HAFM appliance.

Install HAFM client on a remote workstation

Use these steps to install HAFM on a remote client:

1. Verify that the workstation and the Ethernet LAN segment (with the Edge Switch 2/24 attached)

are connected through the Internet.

2. At the workstation, launch the browser application.

3. At the browser, enter the HAFM appliance IP address.

4. The HAFM splash screen is displayed with the following options, see Figure 33.

a. Install HAFM remote client application—Select this option to install the application for your

workstation platform.

b. Download SNMP MIB files—The Management Information Base (MIB) files are provided in

standard ASN.1 syntax and may be installed into the MIB database of any

SNMPv2-compliant Network Management Station.

Figure 33 HAFM remote client install