FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Rack Mount Instructions
97HA-Fabric Manager Server Installation Guide
Install Server
To install the server in the equipment cabinet:
1. If the front bracket portions of the bracket assemblies are installed at the front
of the cabinet (typical installation), install the server through the cabinet front.
2. While fully supporting the server, slide the server and attached slide rails into
the mounting brackets as shown in Figure 84.
Figure 84: Server installation
3. Using a #2 Phillips screwdriver, securely tighten the bar nut screws (four per
assembly, eight total) that connect the bracket assemblies to the
rack-mounting standards.
4. Install one hexagonal-nut standoff per side (two total) to prevent the server
from moving. At the front of the server (as shown in Figure 85), screw a
standoff through the remaining (center) hole where each three-hole bar nut
attaches to the rack-mounting standard. Secure each standoff with a 5/16
open-end wrench.