FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Rack Mount Instructions
95HA-Fabric Manager Server Installation Guide
5. Attach each bracket assembly to the rack-mounting standards as shown in
Figure 82. If the server mounts through the front of the cabinet, ensure the
front bracket portion of the assembly faces the cabinet front.
Figure 82: Bracket installation
a. Slide the mounting bracket flanges between the bar nuts and
rack-mounting standards. Adjust the overall length of each bracket
assembly if required.
b. To allow tolerance for server installation, tighten the three-hole bar nut
screws (bracket-to-rack mounting standard) so the brackets are stable, but
can be moved laterally.
Note: Ensure the bar nut screw washers do not overlap the inside edges of the
rack-mounting standards and mounting brackets. Washer overlap may interfere with
slide rail operation.
c. Using a #2 Phillips screwdriver, securely tighten the bar nut screws (two
per bracket assembly, four total) that connect the front and rear brackets.