FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Rack Mount Instructions
94 HA-Fabric Manager Server Installation Guide
4. Depending on the cabinet depth measured in step 2, attach each front bracket
to a rear (short or long) bracket. If the cabinet depth is under 22 inches, use
one front bracket and one short rear bracket. If the cabinet depth is over 22
inches, use one front bracket and one long rear bracket.
Be sure to choose the slots in the rear bracket which will result in the length of
the combined front and rear bracket to match the cabinet depth measured in
step 2.
a. Using a #2 Phillips screwdriver and two (2) flat-head Phillips machine
screws (#8 x 7/16) per bracket assembly, connect a front and rear bracket
together with a two-hole bar nut as show in Figure 81.
Figure 81: Front and rear bracket assembly
Partially tighten each screw so that the assembly is held together but not
completely secure. This allows for slight adjustment of the bracket length
during installation in the cabinet.
b. Ensure the left and right bracket assembly lengths are equal to the cabinet
depths recorded in step 2.