FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Rack Mount Instructions
90 HA-Fabric Manager Server Installation Guide
Tools Required
Tools required to install the server and associated hardware include a:
■ #2 Phillips screwdriver.
■ 5/16 open-end wrench.
■ Tape measure.
Kit Contents
The 1U server rack-mount kit contains:
■ These installation instructions.
■ One slide assembly and one hardware kit, containing:
— Two (2) front brackets that attach to the cabinet (20 inches).
— Two (2) rear brackets (long) that attach to the cabinet (15.25 inches).
— Two (2) optional rear brackets (short) that attach to the cabinet
(3.0 inches).
— One (1) left slide rail that attaches to the server (19.25 inches).
— One (1) right slide rail that attaches to the server (19.25 inches).
— Two (2) two-hole bar nuts for bolting the front and rear brackets together.
— Four (4) three-hole bar nuts for attaching the brackets to the
rack-mounting standards.
— Mounting screws:
— Ten (10) pan-head Phillips screws (#10 x 1/2) with split lock and flat
washers that secure the bracket assemblies to the vertical
rack-mounting standards.
— Ten (10) square alignment washers (required only for HP 9000,
10000 and 11000 series racks).
— Ten (10) pan-head Phillips screws (M4 x 10 centimeter) with split
lock and flat washers that secure the slide rails to the server.
— Four (4) flat-head Phillips machine screws (#8 x 7/16) that secure the
two-hole bar nuts, front brackets, and rear brackets.
— Two (2) hexagonal-nut standoffs.