FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Configuration
33HA-Fabric Manager Server Installation Guide
Configure Private LAN Addresses
Note: Before starting this procedure, ensure that the LAN 2 interface is physically
connected to the LAN. An LCD display of 0.0.0.0 indicates a physical LAN connection
is not present.
You can configure the private LAN connection (LAN 2) using one of the
following methods:
■ Use Dynamic Host Control Protocol (DHCP) to assign the HAFM server IP
address, subnet mask, and default gateway IP address. You can either
auto-detect or manually select the DNS server IP address.
■ Manually enter the HAFM server IP address, subnet mask, default gateway IP
address, and DNS server IP address.
Configure Private LAN Addresses Using DHCP
To configure TCP/IP network information for the private LAN connection
(LAN 2) using DHCP:
1. At the HAFM server’s LCD panel, press ENTER. The Welcome!! or
operational information message changes to the following (Figure 23):
Figure 23: LCD panel (password entry)
2. Using the button to increment a digit, the button to decrement a digit, the
button to move the cursor left, and the button to move the cursor right,
input the default or changed password, and press ENTER. The LAN 2
Setting?? message displays at the LCD panel.
3. Press ENTER and the following message displays (Figure 24) to allow the
selection of DHCP.
Figure 24: LCD panel (DHCP selection)
Input Password:
0****
Use DHCP?
NO!