FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

Initial Setup
24 HA-Fabric Manager Server Installation Guide
Power On the HAFM Server
To power on the HAFM server:
1. As shown in Figure 3, connect the AC power cord to the server and to a
facility power source or rack power strip that provides single-phase, 90 to 264
VAC current.
When the power cord is connected, the HAFM server powers on and performs
power-on self-tests (POSTs). During POSTs:
■ The green liquid crystal display (LCD) panel illuminates.
■ The green hard disk drive (HDD) LED blinks momentarily, and processor
speed and random-access memory information display momentarily at the
LCD panel.
■ After a few seconds, the LCD panel displays the following message
pertaining to boot sequence selection (Figure 4):
Figure 4: LCD panel during boot sequence
2. Ignore the message. After ten seconds, the server performs the boot sequence
from the basic input/output system (BIOS). During the boot sequence, the
server performs additional POSTs and displays the following operational
information at the LCD panel:
■ Host name.
■ System date and time.
■ LAN 1 and LAN 2 IP addresses.
■ Central processing unit (CPU) temperature.
■ Hard disk capacity.
■ Virtual and physical memory capacity.
After successful POST completion, the LCD panel displays a Welcome!!
message, then continuously cycles through and displays server operational
information.
3. If a POST error or other malfunction occurs, refer to “HAFM Server
Diagnostics” on page 119 to isolate the problem.
Boot from LAN?
Press <Enter>