FW 05.01.00 and SW 07.02.00 hp StorageWorks HA-Fabric Manager Server Installation Guide

HAFM Server Diagnostics
120 HA-Fabric Manager Server Installation Guide
MAP 0000: Start MAP
Substitute the following procedure for the one described in Step 6 of MAP 0000:
Start MAP in Director or Edge Switch service guides.
6
Reboot the HAFM server.
1. At the Windows 2000 desktop, click Start at the left side of the task bar
(bottom of the desktop), then select Shut Down. The Shut Down Windows
dialog box displays.
2. Select the Shut Down option from the list box and click OK. The HAFM
server powers down.
3. Wait approximately 30 seconds and press the power button on the liquid
crystal display (LCD) panel to power on the server and perform power-on
self-tests (POSTs). During POSTs:
a. The green LCD panel illuminates.
b. The green hard disk drive (HDD) LED blinks momentarily, and processor
speed and random-access memory information display momentarily at the
LCD panel.
c. After a few seconds, the LCD panel displays the following message
pertaining to boot sequence selection (Figure 88):
Figure 88: LCD panel during boot sequence
d. Ignore the message. After ten seconds, the server performs the boot
sequence from the basic input/output system (BIOS). During the boot
sequence, the server performs additional POSTs and displays the
following operational information at the LCD panel:
—Host name.
— System date and time.
— LAN 1 and LAN 2 IP addresses.
— Central processing unit (CPU) temperature.
Boot from LAN?
Press <Enter>