fw 05.01.00 and sw 07.01.00 edge switch 2/24 product manager user guide

Monitoring and Managing the Switch
63Edge Switch 2/24 Product Manager User Guide
■ Unit Beaconing Indicator. The amber indicator blinks if unit beaconing is
enabled. Enable and disable unit beaconing by right-clicking on the front
or rear view away from a hardware component and selecting Enable Unit
Beaconing from the menu. You can only enable beaconing if there are no
system errors (the system error indicator is off).
Rear View
7. Power Supply Status: Each AC power connector indicates the location of an
internal power supply. An amber, service-required LED indicator is located in
the upper left corner of each AC power connector. The indicator illuminates if
the power supply has failed and requires service. The indicator is off if the
power supply is active.
When a blinking red and yellow diamond ( ) displays on a power connector,
like in Figure 10 on page 61, the internal power supply for that connector
failed. In this case, the green indicator to the top left of the connector will not
illuminate. When the green indicator is on and no status symbol displays, the
power supply is operational. Note that the switch operates with one power
supply failure, however, replace the power supply as soon as possible to retain
redundancy.
Obtaining Hardware Information
This section explains how to access the FRU Properties, Port Properties, and
Switch Properties dialog boxes.
Displaying FRU Information
Display the FRU Properties dialog box using one of the following methods:
■ Double-click on a FRU, such as a power supply module illustrated in the
Hardware View.
■ Select a FRU in the Hardware View, then select FRU and FRU Properties
from the Product menu.
■ Double-click on a row in the FRU List view.
The FRU Properties dialog box displays FRU name, slot position relative to
identical FRUs installed in the chassis, and active or failed state.