fw 05.01.00 and sw 07.01.00 edge switch 2/24 product manager user guide

Product Manager Messages
197Edge Switch 2/24 Product Manager User Guide
Stop diagnostics failed.
The test was not running.
The action to stop
diagnostics failed
because the test was not
running.
N/A. Informational
message.
Switch Binding was
removed from attached
devices that are also
participating in Port
Binding. Please review
the Port Binding
Configuration.
The device WWNs were
removed from the Switch
Membership List
(SANtegrity Binding
feature), but you should
note that one or more of
these devices still has
security control in port
binding.
Verify that the security level
for each device is as
required by reviewing the
Bound WWN list in the
Configure Ports dialog box.
System diagnostics
cannot run. The
Operational Status is
invalid.
System diagnostics
cannot run on switches
with failed ports.
Replace failed ports.
The add firmware
process has been
aborted.
User has ended the add
firmware process.
N/A. An informational
message.
The data collection
process failed.
An error occurred in the
data collection process.
Contact support personnel.
The data collection
process has been
aborted.
User has ended the data
collection process.
N/A. An informational
message.
The default zone must be
disabled to configure.
The message displays
when the user attempts to
change the
interoperability mode to
open fabric and the
default zone is enabled
Disable the default zone
and repeat the operation.
The switch is busy saving
maintenance
information.
The switch is busy with a
maintenance operation.
Retry the operation later. If
the condition persists,
contact support personnel.
The following parameters
cannot be disabled while
Enterprise Fabric Mode is
active: Insistent Domain
ID, Rerouting Delay,
Domain RSCN's.
User attempted to
disable these parameters
in the Configure Switch
Parameters dialog box
while Enterprise Fabric
Mode is enabled.
Disable Enterprise Fabric
Mode through the
Enterprise Fabric Mode
dialog box in the HAFM,
then disable the
parameters.
Table 5: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Message Description Action