fw 05.01.00 and sw 07.01.00 edge switch 2/24 product manager user guide

Product Manager Messages
195Edge Switch 2/24 Product Manager User Guide
Open Trunking is not
installed for this product.
Please contact your sales
representative.
The Open Trunking
feature key has not been
enabled. This message
only displays if the
optional Open Trunking
feature is installed.
Enter the feature key into
the Configure Feature Key
dialog box and enable the
key. If you require a feature
key, see your account
representative.
Performing this operation
will change the current
state to Offline.
This operation causes the
switch to go offline.
N/A. An informational
message.
Performing this operation
will change the current
state to Online.
This operation causes the
switch to go online.
N/A. An informational
message.
Performing this action
will overwrite the
date/time on the switch.
Warning that occurs
when configuring the
date and time through
the Configure Date and
Time dialog box, that the
new time or date will
overwrite the existing
time or date set for the
switch.
Verify that you want to
overwrite the current date
or time.
Periodic Date/Time
synchronization must be
cleared before enabling
switch clock alert.
Action cannot be
performed because
Periodic Date/Time
Synchronization option is
active.
Click Periodic Date/Time
Synchronization check box
in Configure Date and
Time dialog box (Configure
menu) to clear check mark
and disable periodic
date/time synchronization.
Port binding was
removed from attached
devices that are also
participating in Switch
Binding.
Informational message.
User has removed Port
Binding from attached
devices, but one or more
of these devices is still
controlled by Fabric
Binding.
Review the Switch Binding
Membership List to
determine if the devices
should be members.
Port cannot swap to itself. Port addresses entered in
the Swap Ports dialog
box are the same.
Make sure that address in
the first and second port
address fields are different.
Port diagnostics cannot
be performed on an
inactive port.
This displays when port
diagnostics is run on a
port in an inactive state.
Run the diagnostics on an
active port.
Table 5: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Message Description Action