fw 05.01.00 and sw 07.01.00 edge switch 2/24 product manager user guide

Product Manager Messages
184 Edge Switch 2/24 Product Manager User Guide
Are you sure you want to
send firmware version?
Confirmation to send a
firmware version to the
switch.
Click Yes to confirm
sending the firmware
version to the switch, or no
to cancel the operation.
Cannot disable Switch
Binding while Enterprise
Fabric Mode is active
and the switch is Online.
User attempted to
disable switch binding
through the Switch
Binding Change State
dialog box, but
Enterprise Fabric Mode
is enabled.
You must either disable
Enterprise Fabric Mode
using the Enterprise Fabric
Mode dialog box in the
HAFM application or set
the switch offline before you
can disable Switch Binding.
Cannot disable Insistent
Domain ID while Fabric
Binding is active.
User attempted to
disable the Insistent
Domain ID parameter
through the Configure
Switch Parameters
dialog box, but Fabric
Binding is enabled.
Disable Fabric Binding
through the Fabric Binding
dialog box before disabling
these parameters.
Cannot enable
beaconing on a failed
FRU.
Occurs when selecting
Enable Beaconing option
for a failed FRU.
Replace FRU and enable
beaconing again or enable
beaconing on operating
FRU.
Cannot enable
beaconing while the
system error light is on.
Beaconing cannot be
enabled while the system
error light is on.
Select Clear System Error
Light from Product menu to
clear error light, then
enable beaconing.
Table 5: StorageWorks Edge Switch 2/24 Product Manager Messages (Continued)
Message Description Action