FW V06.XX/HAFM SW V08.02.00 HP StorageWorks SNMP Reference for Directors and Edge Switches (AA-RQ7BE-TE, July 2004)

SNMP Support
123SNMP Reference for Directors and Edge Switches
FcConnUnitPo
rtStatCountPri
mitiveSequenc
eProtocolError
s
Counter6
4
stPrimSeqProtoErrors (Only
supports low 32-bits of
counter, high 32-bits are set to
zero.)
R Count of primitive
sequence protocol errors
detected at this port. This
count is part of the Link
Error Status Block (LESB).
(FC-PH 29.8). Note, this is
a Fibre Channel only stat.
FcConnUnitPo
rtStatCountLos
sofSignal
Counter6
4
stSigLosses (Only supports low
32-bits of counter, high
32-bits are set to zero.)
R Count of instances of
signal loss detected at
port. This count is part of
the Link Error Status Block
(LESB). (FC-PH 29.8).
Note, this is a Fibre
Channel only stat.
FcConnUnitPo
rtStatCountLos
sofSynchroniz
ation
Counter6
4
stSyncLosses (Only supports
low 32-bits of counter, high
32-bits are set to zero.)
R Count of instances of
synchronization loss
detected at port. This
count is part of the Link
Error Status Block (LESB).
(FC-PH 29.8). Note, this is
a Fibre Channel only stat.
FcConnUnitPo
rtStatCountInv
alidOrderedS
ets
Counter6
4
Not supported R Count of invalid ordered
sets received at port. This
count is part of the Link
Error Status Block (LESB).
(FC-PH 29.8). Note, this is
a Fibre Channel only stat.
FcConnUnitPo
rtStatCountFr
amesTooLong
Counter6
4
Not supported R Count of frames received
at this port where the
frame length was greater
than what was agreed to
in FLOGI/PLOGI. This
could be caused by losing
the end of frame delimiter.
Note, this is a Fibre
Channel only stat.