FW V06.XX/HAFM SW V08.02.00 HP StorageWorks Embedded Web Server User Guide (AA-RTDRC-TE, July 2004)

Error Messages
163Embedded Web Server User Guide
Error 106: Invalid
Threshold Scope
The scope of a threshold
alert is not set to a valid
state before the user
activates an alert.
Set the scope of the
threshold alert, then try to
activate the alert.
Error 107: Invalid
Threshold State
The scope of a threshold
alert must be set before
the user activates an alert.
Set the scope of the
threshold alert, then try to
activate the alert.
Error 108: Invalid TTA
Type
The type of the throughput
threshold alert (TTA) has
not been set.
Set the type of the TTA,
then try to activate the
alert.
Error 109: Invalid CTA
Type
The type of the counter
threshold alert has not
been set.
Set the type of the CTA,
then try to activate the
alert.
Error 110: Invalid Percent
Utilization
The type of the throughput
threshold alert has not
been set.
Set the type of the TTA,
then try to activate the
alert.
Error 111: Invalid
Threshold Type
The type of the threshold
alert is not valid.
Configure the type of the
throughput threshold alert
to one of the types found
in the enumerated table
for TTAs.
Error 112: No Threshold
Definition Given
The threshold value for
the alert was not
configured before the user
attempted to activate the
alert.
Set the threshold value,
then try to activate the
alert.
Error 115: Invalid Switch
Speed
The request cannot be
completed because the
switch is not capable of
operating at the
configured speed.
Consult the
installation/service
manual to determine the
speed capabilities of your
product.
Error 116: Switch Not
Capable of 2 Gb/sec
The request cannot be
completed because the
switch is not capable of
operating at 2 Gb/s.
Consult the
installation/service
manual to determine the
speed capabilities of your
product.
Table 9: Embedded Web Server Messages (Continued)
Message Description Action