FW V06.XX/HAFM SW V08.02.00 HP StorageWorks CLI Reference Guide for Directors and Edge Switches Reference Guide (AA-RQ7AE-TE, July 2004)

perf.thresholdAlerts.counter.addAlert
183CLI Reference Guide for Directors and Edge Switches
Syntax
addAlert name
Purpose
This command configures a new counter threshold alert and assigns it a name.
The new alert is assigned default settings which can then be changed using the
other counter threshold alert commands.
The default settings for a new counter threshold alert are as follows:
■ Ports: None
■ Counter: None
■ Increment: 100
■ Interval: 60 minutes
■ State: Disabled
Parameters
This command has one parameter:
Note: Although the system supports a name length of 64 characters, you may want to
use a much shorter name. Some commands that display the threshold name show a
maximum of 51 characters. If you specify lengthy names, you can display the
complete name by entering the comma-delimited mode using the commaDelim
command.
Command Example
Root> perf thresholdAlerts counter addAlert checklinks
perf.thresholdAlerts.counter.addAlert
name Specifies the name of the new counter threshold alert.
This name can consist of any ASCII characters up to a
maximum length of 64 characters. To use spaces or
special characters in this name, put quotation marks
around the name. This parameter is case-sensitive.