FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-43
config
state for either the E_Port or N_Port interface. The default setting will
cause the port to use the outgoing state configure for the
corresponding interface (either E_Port or N_Port).
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one required parameter, and one optional
parameter:
Command Example
Root> config security authentication port override 138
enable
config.security.authentication.port.show
Syntax show
Purpose This command displays a table displaying the outgoing override
state for each port.
Parameters This command has no parameters.
Command Example
Root> config security authentication port show
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016 and 3216
0-15 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032 and 3232
0-31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
overrideState This parameter sets the outgoing
authentication state for the specified port.
Valid values are enable, disable, or default.
Boolean 1 and 0 values may also be
substituted.