FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-39
config
config.security.authentication.interface.nport.sequence
Syntax sequence method1 [method2]
Purpose This command sets the sequence that the N_Port interface will use to
authenticate. When the preferred method cannot be contacted, the
backup method will be used to authenticate the remote end of the
ISL.
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one required parameter, and one optional
parameter:
NOTE: A preferred method of local and a backup method of RADIUS is not
an accepted combination because the local method can always be contacted.
Command Example Root> config security authentication interface nport
sequence RADIUS local
config.security.authentication.interface.osms.outgoing
Syntax outgoing enabledState
Purpose This command determines if outgoing authentication is used on all
OSMS requests. The OSMS key must be configured prior to setting
the outgoing state to enabled.
method1 This sets the preferred method of
authentication. Accepted values are local or
RADIUS.
method2 This optional parameter sets the backup
method of authentication. This backup
method is used when the preferred method
cannot be contacted. Accepted value is local.