FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-37
config
Command Example Root> config security authentication interface cli
sequence RADIUS local
config.security.authentication.interface.eport.outgoing
Syntax outgoing enabledState
Purpose This command determines if outgoing CHAP authentication is used
on E_Port connections. If this is enabled, the switch will issue a
CHAP challenge to authenticate the remote end of the ISL.
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
Parameters This command has one parameter:
Command Example
Root> config security authentication interface eport
outgoing disable
config.security.authentication.interface.eport.sequence
Syntax sequence method1 [method2]
Purpose This command sets the sequence that the E_Port interface will use to
authenticate. When the preferred method cannot be contacted, the
backup method will be used to authenticate the remote end of the
ISL.
NOTE: This command requires that the SANtegrity Authentication feature
key be installed.
enabledState This parameter enables and disables
outgoing CHAP authentication on all ISLs.
Accepted values for this parameter are enable
or disable. Boolean 1 and 0 values may also be
substituted.