FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-33
config
Parameters This command has two required parameters:
Command Example
Root> config port swapPortByAddr 1e 1f
config.port.swapPortByNum
Syntax swapPortByNum portNum1 portNum2
Purpose This command will swap two ports given the port numbers. The
ports must be offline to perform this operation.
Parameters This command has two required parameters:
Command Example
Root> config port swapPortByAddr 1e 1f
config.port.type
Syntax type portNumber portType
Purpose This command sets the allowed type for a port.
A port can be configured as an F_Port, an E_Port, or a G_Port. On a
Sphereon 4300 or Sphereon 4500, a port can also be an Fx_port or
Gx_port.
NOTE: On the Sphereon 4300 Switch, the E_Port, G_Port, and GX_Port
options are not valid unless the Fabric Capable feature is enabled. For more
information, see the McDATA Sphereon 4300 Switch Installation and Service
Manual (620-000171).
portAddr1 Port address, in hexidecimal format, of the
desired port to be swapped.
portAddr2 Port address, in hexidecimal format, of the
desired port to be swapped.
portNum1 Port number, in hexidecimal format, of the
desired port to be swapped.
portNum2 Port number, in hexidecimal format, of the
desired port to be swapped.