FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-32
E/OS Command Line Interface User Manual
config
config.port.speed
Syntax speed portNumber portSpeed
Purpose This command sets the speed for a port. A port can be configured to
operate at 1 Gb/sec, 2 Gb/sec, 4Gb/sec, or a negotiated speed. The
port speed can be set only to 1 Gb/sec, if the switch speed is 1
Gb/sec. An attempt to set the port speed to 2 Gb/sec or to negotiate
in a switch with a 1 Gb/sec switch speed results in an error message.
If the port speed is set to negotiate, the port and the device to which it
is attached negotiate the data speed setting to either 1 Gb/sec or 2
Gb/sec.
ATTENTION! Port speed changes temporarily disrupt port data transfers.
Parameters This command has two required parameters:
Command Examples
Root> config port speed 4 2g
Root> config port speed 6 negotiate
config.port.swapPortByAddr
Syntax swapPortByAddr portAddr1 portAddr2
Purpose This command will swap two ports given the port addresses. The
ports must be offline to perform this operation.
portNumber Specifies the port number. Valid values are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0-15 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0-31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140
portSpeed Specifies the speed of the port. Valid values are
1g, 2g, 4g and negotiate.