FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-30
E/OS Command Line Interface User Manual
config
Port Number: 4
Name: Sam’s tape drive
Blocked: false
Type: F Port
Speed: 2 Gb/sec
Rx BB_Credits: 12
config.port.showPortAddr
Syntax showPortAddr
Purpose This command displays the port address configuration for all ports.
NOTE: The command show.port.showPortAddr on page 2-210 has functionality
that is the same as this command.
Parameters This command has no parameters.
Command Example
Root> config port showPortAddr
Output The port configuration is shown as a table of properties. The
following properties are displayed:
Output Example
Port Original Addr Current Addr SwappedPort Num
---- ------------- ------------ ----------------
04 4
15 5
26 7 3
37 6 2
48 8
59 9
6a a
7b b
8c c
...
Port The port number.
Original Addr The original port address of the port.
Current Addr The current port address of the port.
Swapped Port Num If the port is swapped with another port,
it will show the port number of the port it
is swapped with.