FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-25
config
6 130
...
NOTE: The command show.NPIV.config on page 2-193 has functionality that
is the same as this command.
config.openSysMS.setHostCtrlState
Syntax setHostCtrlState HostContrlState
Purpose This command enables or disables Open Systems Management
Server (OSMS) Host Control.
Parameters This command has one parameter:
Command Example
Root> config openSysMS setHostCtrlState enable
config.openSysMS.setState
Syntax setState osmsState
Purpose This command enables or disables Open Systems Management
Server (OSMS) feature. OSMS is a feature that allows host control and
inband management of the switch or director through a management
application that resides on an open-systems interconnection (OSI)
device.
Parameters This command has one parameter.
Command Example
Root> config openSysMS setState 1
HostContrlState This parameter can be set to enable or disable.
Boolean 1 and 0 values may also be
substituted.
osmsState Specifies whether the Open Systems
Management Server is enabled. Valid values are
enable and disable. Boolean 1 and 0 may be
substituted as values.