FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-22
E/OS Command Line Interface User Manual
config
config.ip.lineSpeed
Synopsis lineSpeed speed duplex
Purpose This command sets the Ethernet line speed.
Parameters This command has two parameters. One of the parameters is optional
depending on the combination.
Command Example
Root> config ip lineSpeed 10 half
config.ip.show
Syntax show
Purpose This command shows the LAN configuration.
Parameters This command has no parameters.
Command Example
Root> config ip show
Output The LAN configuration data is displayed as a table that includes the
following properties.
Output Example The output from the config.ip.show command appears as follows:
IP Address: 10.0.0.0
Gateway Address: 0.0.0.0
Subnet Mask: 255.0.0.0
speed The line speed. Options are auto, 10, or 100. If
auto is entered then the optional duplex
should not be entered.
duplex The duplex mode for the connection. Options
are full or half.
IP Address The IP address.
Gateway
Address
The gateway address.
Subnet Mask The subnet mask.