FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

CLI Commands

2-21

config

Output The data is displayed as a table that includes the following

information:

Output Example The output from the config.ficonMS.show command appears as

follows:

Ficon MS State: Disabled

Ficon MIHPTO (seconds): 180

config.ip.ethernet

Syntax ethernet ipAddress gatewayAddress subnetMask

Purpose This command sets the Ethernet network settings.

ATTENTION! The Telnet connection can be lost when these Ethernet

network settings are changed.

NOTE: If the IP address is reconfigured, your Telnet client must be

reconnected to the new IP address. A new login will be requested.

Parameters This command has three parameters:

Command Example

Root> config ip ethernet 10.0.0.0 0.0.0.0 255.0.0.0

Ficon MS State The state of the FICON MS feature.

Ficon MIHPTO The FICON MIHPTO value in seconds.

ipAddress Specifies the new IP address for the director or

switch. The address must be entered in dotted

decimal format (for example, 10.0.0.0).

gatewayAddress Specifies the new gateway address for the

Ethernet interface. The address must be entered

in dotted decimal format (for example, 0.0.0.0).

subnetMask Specifies the new subnet mask for the Ethernet

interface. The address must be entered in dotted

decimal format (for example, 255.0.0.0).