FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-18
E/OS Command Line Interface User Manual
config
config.ficonCUPZoning.deleteControlHost
Syntax deleteControlHost hostNodeWwn
Purpose This command removes one or all control hosts from the Control
Host List used to determine the FICON host(s) capable of viewing all
ports. This list overrides the FCZ port visibility mask.
Parameters This command has one parameter:
Command Example
Root> config ficonCUPZoning deleteControlHost all
config.ficonCUPZoning.setState
Syntax setState ficonCUPZoningState
Purpose This command enables or disables FICON CUP Zoning. The FICON
Management Server feature key must be installed in order to enable
the FICON CUP Zoning State. (The Sphereon 4300 and Sphereon
4500 switches do not accept this command.)
NOTE: If the FICON Management Server is enabled, the default
management style is the FICON Management Style. The Open Systems
Management Style cannot be used.
Parameters This command has one parameter.
Command Example
Root> config ficonCUPZoning setState 1
hostNodeWwn The node WWN of the desired control host,
entered in colon-delimited notation (e.g.,
01:02:03:04:05:06:07:08). You can also enter all
to remove the entire list, if no attached hosts
have supervisory privileges.
ficonCUPZoningState Specifies whether the FICON Management
Server is enabled. Valid values are enable
and disable. Boolean 1 and 0 may be
substituted as values.