FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-16
E/OS Command Line Interface User Manual
config
When no parameters are specified, the command will display the
name, type, and state of all policies. If the optional parameter is
specified, it will display all the information about the policy.
NOTE: If the name parameter is not supplied, then only 50 characters of the
policy name will be displayed. In such cases enable the Comma Delimited
Mode to view the full name.
Command Example Root> config fencing show
Root> config fencing show Policy_1
Output If you do not specify the name parameter, then the output shows the
following information:
Output Example The output from the config.fencing.show command appears follows:
Name Type State
-----------------------------------------------------
Default Protocol Error Policy Protocol Error Disabled
Policy_1 Protocol Error Disabled
The output from the config.fencing.show Policy_1 command appears as
follows:
Name: Policy_1
Ports: E ports
Type: Protocol Error
Limit: 5
Name The name of the policy. This will be
concatenated to 50 characters in the summary
display. You can view the policy full name in
the comma delim mode.
Ports The ports to which the fencing policy will be
applied.
Type The type of the fencing policy.
Limit The number of offenses that are allowed
before a port is disabled.
Period The amount of time that limit of number of
offenses must exceed before a port is fenced.
State The enabled state of the fencing policy.