FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-11
config
Command Example Root> config fencing addPolicy Policy2
NOTE: The maximum number of policies supported is 14.
config.fencing.addPort
Syntax addPort name portNumber
Purpose This command adds a port to the specified fencing policy.
Parameters This command has two parameters:
NOTE: A range of ports is not accepted as a valid input to this command
(e.g., “0-29” is not acceptable).
The port values can also be substituted with one of the following
keywords that will remove all the ports from the alert, and then use a
specific type of port instead of individual port numbers.
Valid values are:
• eport – This adds all active E_ports.
• fport – This adds all active F_ports.
name The name of the fencing policy.
portNumber The port number to add to the fencing policy,
or all, which will add all of the individual
ports to the fencing policy. Valid values for
the port number are:
0–11 for the Sphereon 4300
0–15 for the Sphereon 3016
0-15 for the Sphereon 4400
0–23 for the Sphereon 4500
0–31 for the Sphereon 3032
0–31 for the Sphereon 3232
0-31 for the Sphereon 4700
0–63 for the Intrepid 6064
0–127 and 132–143 for the Intrepid 6140