FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2-2

E/OS Command Line Interface User Manual

Command Overview

Most of the commands in this chapter are listed in alphabetical order

to make them easy to locate. Although the commands can be entered

in any order, depending on the results desired (so long as the tree

structure is followed), the order used herein for the zoning

commands follows a typical order of entry. The various show

commands are usually entered at the end of a group of other

commands to verify configuration changes.

New and Changed Commands

The following CLI commands are new for this edition of the E/OS

Command Line Interface User Manual:

• config.fencing.addPort on page 2-11

• config.fencing.removePort on page 2-12

• config.NPIV.maxPortIDs on page 2-23

• config.port.blocked on page 2-26

• config.port.name on page 2-27

• config.port.rxCredits on page 2-28

• config.port.show on page 2-28

• config.port.speed on page 2-32

• config.port.type on page 2-33

• config.security.authentication.port.override on page 2-42

• config.security.portBinding.bound on page 2-59

• config.security.portBinding.show on page 2-60

• config.security.portBinding.wwn on page 2-61

• config.security.ssl.show on page 2-73

• config.security.ssl.resetKeys on page 2-71

•cconfig.security.ssl.setAPIState on page 2-73

• config.security.ssl.setRenegotiationMB on page 2-72

• config.security.ssl.setWebState on page 2-72