FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-235
show
show.thresholdAlerts.alerts
Syntax alerts
Purpose This command provides the name, type, and enabled state of each
configured threshold alert, including both counter threshold alerts
(CTAs) and throughput threshold alerts (TTAs).
Parameters This command has no parameters.
Command Example
Root> show thresholdAlerts alerts
Output The threshold alert data appears as a table that includes the following
properties:
Name The name of the threshold alert, truncated to 45
characters.
Type The trigger statistic or threshold type of the alert
(abbreviated to 17 characters). These include:
Tx Util TTA - Transmit Utilization.
Rx Util TTA - Receive Utilization.
Tx/Rx Util TTA - Transmit or Receive
Utilization.
Link Resets Sent CTA - Link Resets Sent.
Link Resets Received CTA - Link Resets
Received.
OLS Sent CTA - OLS Sent.
OLS Received CTA - OLS Received.
Link Failures CTA - Link Failures.
Sync Losses CTA - Sync Losses.
Signal Losses CTA - Signal Losses.
Protocol Errors CTA - Primitive Sequence
Errors/Protocol Errors.
Invalid Tx Words CTA - Invalid Tx Words.