FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-229
show
Output The switch configuration data is displayed as a table that includes the
following properties:
Output Example The output from the show.snmp.config command appears as follows:
SNMP Agent State: Enabled
SNMPv3 State: Disabled
FA MIB Version Number: 3.0
Authentication Traps: Enabled
Index Community Name WriteAuth Trap Recipient UDP Port
----- -------------------------------- --------- --------------- --------
1 CommunityName1 Enabled 123.123.123.123 162
2 CommunityName2 Enabled 10.25.25.10 144
3 CommunityName3 Disabled 132.44.85.224 162
4 public Enabled 162
5
6
SNMP Agent State Displays the state of the SNMP agent. If it is
disabled, then the SNMP state will not
respond to any requests, nor will it produce
any traps.
SNMPv3 State The SNMPv3 state.
FA MIB Version
Number
Version of the Fibre Alliance MIB (FA MIB)
that the SNMP agent is configured to use.
Authentication
Traps
Displays the state of authentication traps to be
sent to SNMP management stations when
unauthorized stations try to access SNMP
information from the switch or director.
Index Index in the community table.
Community.
Name
Displays the community name.
WriteAuth The write authorization state of the
community.
Trap Recipient Protocol description of the trap recipient.
UDP Port UDP port number to which the switch or
director will send traps for each recipient. This
value is expressed in decimal and the default
value is 162.