FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-211
show
NOTE: The config.port.showPortAddr on page 2-30 has functionality that is
identical to this command.
Parameters This command has no parameters.
Command Example
Root> show port showPortAddr
Output The port configuration is shown as a table of properties. The
following properties are displayed:
Output Example
Port Original Addr Current Addr SwappedPort Num
---- ------------- ------------ ----------------
04 4
15 5
26 7 3
37 6 2
48 8
59 9
6a a
7b b
8c c
...
Port The port number.
Original Addr The original port address of the port.
Current Addr The current port address of the port.
Swapped Port Num If the port is swapped with another port,
it will show the port number of the port it
is swapped with.