FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-206
E/OS Command Line Interface User Manual
show
Parameters This command has no parameters.
Output This command displays the following optic data:
NOTE: If an Alarm and a Warning threshold have both been exceeded, then
the Alarm state will be displayed because it is of high priority.
Command Example Root> Show Port opticHealth
Output Example The show.port.opticHealth command output appears as follows:
Port Transceiver Overall Health
---- ----------- --------------
0 XPM Normal
1 (Unaddressable)
2 (Unaddressable)
3 (Unaddressable)
4 SFP Normal
5 Unk No Info
6 Unk No info
7 SFP Warning
8 SFP Alarm
...
show.port.opticInfo
Syntax OpticInfo
Port The port number.
Overall Health The overall health of the optic. Possible values
are list below according to priority.
Alarm One or more alarm threshold has been
exceeded.
Warning One or more warning threshold has been
exceeded.
Normal All measurements are within thresholds.
No Info The optic does not support enhanced digital
diagnostics or the state has not been updated
yet.