FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-203
show
Output Example The show.port.nodes command output for a mix of public and private
nodes on a loop appears as follows:
FCAddr BB Crdt RxFldSz COS Port Name Node Name
------ ------- ------- --- ----------------------- -----------------------
612902 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
612903 10 2112 2 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
612904 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
612905 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AB 8 2112 2 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AC 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AD 8 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129AE 10 3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129FD 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
6129FE 10 2,3 00:11:22:33:44:55:00:77 20:11:22:33:44:55:66:77
show.port.opticData
Syntax opticData portNumber
Purpose This command shows the overall optic health, enhanced digital
diagnostic data, and the thresholds for the specified port. At the end
of this display, it will show which measurements have exceeded their
thresholds.
Parameters This command has one parameter.
Command Example
Show.Port> opticData 5
portNumber The port number whose data will be
displayed. Valid values are:
0-15 for the Sphereon 3016
0-15 for the Sphereon 4400
0-31 for the Sphereon 3032
0-31 for the Sphereon 4700
0-63 for the Intrepid 6064
0-143 for the Intrepid 6140 (128-131 are
inaccessible)
0-23 for the Sphereon 4500
0-11 for the Sphereon 4300