FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-196
E/OS Command Line Interface User Manual
show
Output Example The output from the show.openTrunking.config command appears as
follows:
Unresolved Congestion: Enabled
Backpressure: Disabled
Low BB_Credit Threshold (%): 75 (default)
Port Threshold %
---- ------------
1 60 (default)
2 69
3 60 (default)
4 60 (default)
5 90
...
show.openTrunking.rerouteLog
Syntax reroutelog [clear]
Purpose This command displays the Open Trunking Re-route Log
information.
ATTENTION! If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the Open Trunking Re-route Log is lost.
Parameters This command has one optional parameter:
Command Example
show opentrunking reroutelog
NOTE: The clear parameter also clears the log entries for your SAN
management application.
clear This optional parameter causes all re-route log
entries to be cleared.