FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-191
show
more than one device per port for any public loop devices attached to
an FL_Port.
Parameters This command has no parameters.
Command Example
Root> show nameServer
Output The device information data is displayed as a table that includes the
following properties:
Output Example The output from the show.nameServer command appears as follows:
Type The type of the port (N, NL, F/NL, F, FL, E, B).
Port Id The 24-bit Fibre Channel address.
Port Name The port WWN of the attached device.
Node Name The node WWN of the attached device.
COS The class of service (for example, 1; 2; 3; 4; 5; 6;
F; 1,2; 2,3).
FC4 Types The FC4 types registered for this device. One or
more numbers display in this field. The
numbers in this field correspond to the list at
the bottom of the output example below.