FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-188
E/OS Command Line Interface User Manual
show
Power 0 Active 470-000399-700 223456789 Off 831
Fan 0 Active 470-000399-700 223456789 Off 831
show.ip.ethernet
Syntax ethernet
Purpose This command displays Ethernet attributes.
Parameters This command has no parameters.
Command Example
Root> show ip ethernet
Output The Ethernet attributes data is displayed as a table that includes the
following properties:
Output Example The output from the show.ip.ethernet command appears as follows:
LAN Information
IP Address: 144.49.10.15
Gateway Address: 144.49.10.1
Subnet Mask: 255.255.255.0
show.linkIncidentLog
Syntax linkIncidentLog [clear]
Purpose This command displays the contents of the link incident log on the
director or switch.
ATTENTION! If the switch is restarted (as occurs during IPL, IML,
configuration reset, feature key installation, or firmware load) or is power
cycled, the information in the link incident log is lost.
IP Address The IP address for the Ethernet adapter as set in
the config.ip.ethernet command.
Gateway
Address
The gateway address for the Ethernet adapter
as set in the config.ip.ethernet command.
Subnet Mask The subnet mask for the Ethernet adapter as set
in the config.ip.ethernet command.