FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-185
show
Output The data is displayed as a table that includes the following
properties:
Output Example
Root> show fencing
Name Type State
------------------------ --------------- --------
Default_Protocol_Errors Protocol Errors Enabled
Protocol Errors #2 Protocol Errors Disabled
Safety #2 Protocol Errors Enabled
Root> show fencing Protocol Errors #2
Name: Protocol Errors #2
Ports: 2,4-7,20-24
Type: Protocol Errors
Limit: 5
Period: 1800 seconds
State: Disabled
show.ficonCUPZoning
Syntax ficonCUPZoning
Purpose This command displays the contents of the host control list and the
enabled state of FICON CUP Zoning.
NOTE: The command config.ficonCUPZoning.show on page 2-19 has
functionality that is the same as this command.
Name The name of the policy. This will be
concatenated to 50 characters in the summary
display. The policy full name will be shown
in comma-delim mode.
Ports The ports to which the fencing policy will be
applied.
Type The type of the fencing policy.
Limit The number of offenses that are allowed
before a port is disabled.
Period The amount of time that limit of number of
offenses must exceed before a port is fenced.
State The enabled state of the fencing policy.