FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-184
E/OS Command Line Interface User Manual
show
Output The features data is displayed as a table that includes the following
properties:
Output Example The output from the show.features command appears as follows:
Installed Feature SetFeatureState
---------------------------------------------------
Open Systems Management ServerOSMSEnabled
Flex Ports8 Flex PortsEnabled
SANtegrityFabric BindingActive
SANtegritySwitch BindingEnabled
SANtegrityEnterprise FabricsActive
Open TrunkingOpen TrunkingEnabled
show.fencing.policies
Syntax fencing [name]
Purpose This command displays a table of the configured fencing policies. If a
specific policy name is given, then a full description of the policy is
shown.
Parameters This command has one optional parameter, an individual policy
name. If an individual policy name is given, then a detailed
description will be shown for the specified policy. If no parameter is
given, then a summary of all policies will be shown.
Command Example
Root> show fencing
Root> show fencing Protocol Errors #2
Installed Feature
Set
The feature set installed using a feature key.
Only installed keys are displayed.
Feature Individual features within each set. In many
cases, there is only one feature within each
feature set.
State The state of the individual feature. Fabric-wide
features are displayed as Active/Inactive.
Switch-centric features are displayed as
Enabled/Disabled.