FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-181
show
show.fabric.traceRoute
Syntax traceRoute source destination
Description This command retrieves the route between two nodes in the fabric.
Parameters This command has two parameters:
Command Example
Root> show fabric traceRoute
Output
source The source port for the trace route. This can be
either a Port ID or a WWN.
destination The destination port for the trace route. This
can be either a Port ID or a WWN.
Return code The return value. Possible values are:
Command Completed Successfully
Command Not Supported in Next Switch
No Response from Next Switch
Maximum Hop Count Reached
Source Port not in Fabric
Destination Port not in Fabric
Devices not in Common Zone
No Route Between Designated Ports
No Additional Explanation
Fabric Busy
Fabric Build in Progress
Unable to run a trace route at this time
Number of Entries The number of entries returned from the trace
route.
Switch WWN The switch WWN at that point in the trace
route.
Domain ID The switch Domain ID at that point in the
trace route.
Ingress Port WWN The Ingress Port WWN taken by the trace
route.