FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-173
show
Output Example The output of the show.epFrameLog.nowrap command appears as
follows:
Count Date/Time Port # Direction SOF EOF Payload Size
------ --------------- ------ --------- --- --- ------------
39 11/24/03 11:30A 39 O i3 n 2112
Header: 22000026 000000EF E1000000 00000000 FFFF0000 00000000
PL: 00010203 04050607 08090A0B 0C0D0E0F 10111213 14151617 18191A1B 1C1D1E1F
38 11/24/03 11:30A 38 I i3 n 2112
Header: 22000026 000000EF E1000000 00000000 FFFF0000 00000000
PL: 00010203 04050607 08090A0B 0C0D0E0F 10111213 14151617 18191A1B 1C1D1E1F
37 11/24/03 11:30A 38 O i3 n 2112
Header: 22000025 000000EF E1000000 00000000 FFFF0000 00000000
PL: 00010203 04050607 08090A0B 0C0D0E0F 10111213 14151617 18191A1B 1C1D1E1F
show.epFrameLog.setTrigger
Syntax setTrigger portNumber offStart bitStart offEnd bitEnd
Purpose This command sets a logging trigger value for the embedded port
frame log.
Parameters This command has five parameters:
Command Example
show.EPFrameLog> setTrigger 5 0 FFXXXXX3452 0 FBXXXXX3321
portNumber The port to monitor this trigger on. Valid
values are:
0–11 for the Sphereon 4300
0–23 for the Sphereon 4500
0-15 for the Sphereon 4400
0-31 for the Sphereon 4700
offStart The offset for the start bit pattern.
bitStart The bit pattern that will trigger the logging. 'X'
or 'x' can be used as a wild card.
offEnd The offset for the end bit pattern.
bitEnd The bit pattern that will end the logging. 'X' or
'x' can be used as a wild card.