FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-170
E/OS Command Line Interface User Manual
show
Command Example Root> show EPFrameLog config
Filter Class F Frames: Disabled
Filter Port: 15
Start Offset: 0
Start Bit Pattern: FFXXXXX3452
End Offset: 0
End Bit Pattern: FBXXXXX3321
Trigger State: Active
Num of Entries: 6
Start Condition Met: True
End Condition Met: False
show.epFrameLog.disableTrigger
Syntax disableTrigger
Purpose This command clears the embedded port frame log trigger, which
was configured with the command show.epFrameLog.setTrigger.
Parameters This command has no parameters.
Command Example
Root> show epFrameLog disableTrigger
show.epFrameLog.filterClassFFrames
Syntax filterClassFFrames [enable]
Purpose This command will turn on or off the ability to filter out Class-F
frames, or show its current state. When the filtering is enabled,
everything but Class-F frames will be logged. This setting will not be
stored in NV RAM and will not persist after IML.
End Bit Pattern The bit pattern that triggers the logging to
end.
Start Condition
Met
True if the start condition was met.
End Condition Met False if the end condition was not met.