FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
CLI Commands
2-169
show
Output Example Date/Time Action Source User Id
---------- ----------- ------- -------------
11/24/03 04:18P Switch set online CLI 172.16.22.23
11/24/03 03:38P Switch name modifiedCLI 172.16.22.23
11/24/03 03:38P Switch set offline CLI 172.16.22.23
11/24/03 11:27A Firmware downloaded Web 172.60.5.40
show.epFrameLog.config
Syntax config
Purpose This command shows the current embedded port frame log settings.
Parameters This command has no parameters.
Command Example
Root> show epFrameLog config
Output The output from this command contains the following data:
Filter Class F
Frames
If enabled, then filtering of Class F frames will
take place.
Filter Port The port that is being filtered on.
Trigger State The state of the trigger. Active if the trigger
conditions have not been met.
Num of Entries Number of frames that have been logged since
the start condition was met.
Start offset The number of bytes into the frame to where
the start bit pattern will be looked for.
Start Bit Pattern The bit pattern that triggers the logging to
begin.
End Offset The number of bytes into the frame to where
the end bit pattern will be looked for.