FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

2
2-168
E/OS Command Line Interface User Manual
show
•show.features
• show.security.portbinding
• show.security.switchbinding
• show.security.fabricbinding
• show.openTrunking.config
• show.thresholdAlerts.alerts
• show.fabric.topology
• show.fabric.nodes
• show.security.switchACL
• show.ficonCUPZoning
• show.FencingPolicies
show.auditLog
Syntax auditLog [clear]
Purpose This command displays the entries of the audit log after the last time
the log was cleared.
Parameters This command has one optional parameter:
Command Example
show auditLog
Output The output from this command displays the following data:
clear Adding the optional clear parameter removes
all entries from the log. If the log is full, it will
resume collecting log entries.
Date/Time The date and time of the log entry.
Action Type of audit log event.
Source Source of audit log event.
User ID Identifier of the user that made the
command. Usually an IP address.