FW 08.01.00 McDATA E/OS Command Line Interface User Manual (620-000134-740, November 2005)

CLI Commands

2-167

show

The show branch of the CLI command tree contains commands that

display, but do not change, stored data values. The displayed output

that results from these commands is not necessarily identical with the

output from the show commands that are within the other CLI

command tree branches, for example, config.port.show.

The commands in the show branch can by used by either the

administrator or the operator.

show.all

Syntax all

Purpose This command displays all configuration and status information that

are available. The command results in a sequential display of the

output of other CLI show commands. This set of show commands

returns the full configuration and status of the switch and fabric.

Parameters This command has no parameters.

Command Example

Root> show all

Output The output of this command is a sequential display of the output of

other CLI show commands. The commands are displayed in the

following order:

• show.ip.ethernet

• show.system

•show.switch

• show.port.config

•show.frus

• config.snmp.show

• show.zoning

• show.port.state

• show.port.info

• show.port.technology

• show.loginserver